Table of Contents
Advertisement
Operating Instructions
Daily Start-Up
[1] Check that the level of processing solutions is at the Overflow Weir. If the solutions are not at the Overflow
Weir, place film under the Middle Film Sensor to fill the Tank.
[2] Install the Top Cover on the processor.
[3] In Low Water Usage Mode, close the Wash Drain Valve by rotating it
[4] Turn on the water supply to the processor.
[5] Check that the Developer and Fixer Replenisher Tanks contain enough solution for the day's operation.
[6] Check that the Feed Tray is clean.
[7] Turn on the processor by moving the Main Circuit Breaker CB1 to the "1" position.
[8] Allow the processor to warm up.
• 10 to 20 minutes in average site conditions
• up to 45 minutes in extreme site conditions
[9] When the Ready Indicator illuminates and the Wait Indicator turns off, feed a test sheet of pre-exposed, non-
processed film or a new sheet of cleanup film to verify correct roller transport and operation of the processor.
• the solutions are at the correct temperature
• the Dryer is at the setpoint temperature
• you may feed film
• the solutions are at the correct temperature
• the Dryer has not reached setpoint temperature
• emergency films may be run, but may exit wet or damp
• If films are wet and feel tacky when they exit the Dryer Assembly, then the Dryer setpoint temperature is
too low.
• If films are over dry and feel hot to the touch when they exit the Dryer Assembly, then the Dryer setpoint
temperature is too high.
Note
Using previously processed film as clean-up film can contaminate the solution in the Developer Tank due to the
residual Fixer solution on that film.
Figure 12 Preparing for Daily Start-Up
981089 – September 1995
Ready
Indicator
1
/
turn.
4
Wash Drain Valve
Main Circuit Breaker CB1
Operating Instructions
Feed Tray
H130_0019BCJ
H130_0019BA
19
Advertisement
Table of Contents
