Kodak HEALTH SCIENCES MINILOADER 2 Plus Low Voltage Stand-Alone Installation Instructions Manual page 26

II 3420
10. Using an 18 x 24 or 24 x 30 CASSETTE, stick a FILM to the SCREEN, enter the CASSETTE and make
sure the FILM is detected by PHOTOCELL FC4. Check that the CASSETTE INJECTOR is blowing in
the correct place to remove the film from the SCREEN.
11. Check the operation of all other PHOTOCELLS. If the MINILOADER is a STAND-ALONE unit,
remember to check the RECEIVING MAGAZINE full setting (75 to 85 FILMS for separate collection,
55 - 65 FILMS for mixed format collection).
12. Check the MAGAZINE OPENING LEVERS have the correct clearance, 6 ±1 mm, from the MAGAZINE
TABS. See the SERVICE MANUAL.
13. Check the operation of the OPERATOR KEYPAD, the LIGHT BAR and the DISPLAY.
14. Check the settings of the PARAMETERS, see TABLE. Also see the THEORY GUIDE for a full
description of the PARAMETERS and details of how to set them. NOTE :- If the MINILOADER is
interfaced to a PROCESSOR, you must set the PARAMETER P4, "GAP BETWEEN FILMS" to suit the
speed of the PROCESSOR being used. IMPORTANT :- If the PROCESSOR has adjustable speeds which
can be selected by the OPERATOR, the PARAMETER must be set to suit the slowest speed being used.
PARAMETER
P1
P2
P3
P4
P5
P8
P9
P10
P11
P12
© Kodak Ltd.
DESCRIPTION
Cassette air blow pause
Magazine film separation blow pause
Multiple film load detector pause
Gap between films
Tilt pause
Air blow cassette opening 18 x 24
Air blow cassette opening 24 x 30
Display brightness
Multiple film check 18 x 24
Multiple film check 24 x 30
Page II-26
INSTALLATION INSTRUCTIONS
STANDARD
RANGE
VALUE
1.5 Sec 1.5 - 3.5 Sec
1.5 Sec 1.5 - 3.5 Sec
0.5 Sec 0.3 - 2.8 Sec
Depends on
0.0 - 20.0 Sec
processor
2.0 Sec 1.5 - 3.5 Sec
30 026 - 032
30 026 - 032
1 1 - 4
155 149 - 160
148 143 - 153
January 1995