Note To The User; Warning And Safety Instructions - Kodak 9000 Installation Manual

Note to the User

1–2 About This Guide
Note to the User
WARNING
X-rays can be harmful and dangerous if not used properly. The
instructions and warnings contained in this guide must be therefore
carefully followed.
As a manufacturer of radiology units that conform to stringent radiological protection
standards in force throughout the world, we guarantee a maximum degree of protection against
radiation hazards. Nonetheless, you are handling a radiology unit specially designed to emit
x-ray doses in order to carry out a medical diagnosis.
The room in which your radiology Unit is to be installed must comply with all official
regulations applicable to protection against radiation. You must install your radiology unit in a
room protected against x-ray emission. This room must reduce the frequency interferences of
the 30MHz to 1GHz band to at least 12db.
Your local representative will assist you in the initial use of your radiology Unit and will
supply any relevant information you may require.
To use and operate your panoramic unit and your digital imaging software you must follow the
instructions contained in this guide.

Warning and Safety Instructions

When operating the Kodak 9000 unit, observe the following warning and safety instructions:
DANGER OF ELECTRIC SHOCK
This is an electrical Unit. DO NOT expose it to water spray. Such action
may cause an electric shock or a malfunction of the Unit.
For maximum safety, advise the patient not to look at the beam.
Before turning on the beams, lower the Frankfurt plane beam to
the lowest level. While making adjustments, ensure that the beam
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT is not directed into the patient's eyes.
Maximum laser output:1mW,650nm
IEC60825-1:1993+A1:1997+A2:2001
LASER WARNING