Yamaha T8 Rigging Manual page 318

Outboard Rigging Guide - 2001
6. Check the steering movement for smooth
operation.
N O T E : With the friction lever turned fully to the
right, check the tiller for smooth movement.
7. Install the fuel hose 1.
WARNING
F it the fuel hose into the clamp securely.
8. Install the battery lead 2 and extension wire
harness 3 under the shift cable
tle cable b .
Set the battery lead 2 and extension
N O T E :
wire harness 3 under the shift cable
tle cable b .
9. Install the screw 4.
Completion Check
Static Check
1. Check the shift operation. Make sure the shift
action is smooth for Forward, Neutral and
Reverse.
2. Check the throttle operation for smoothness
from fully closed to fully open.
N O T E :
operation.
a and throt-
3. Check steering friction to make sure proper
friction is obtained. Move the tiller handle tilt
a
and throt-
up/down and check that the cables and wires
are not stretched.
4. Check the power trim/tilt switch.
a. Connect the battery.
b. Push and hold the switch to "UP", the
c. Push and hold the switch to "DN", the
d. Release the switch, the motor will stop at
6-38
F40 4-Cyl., F/T50 Tiller Handle Kit
Shift forward and then check the throttle
motor will tilt up.
motor will tilt down.
its current position.