Yamaha T8 Rigging Manual page 285

Outboard Rigging Guide - 2001
8. Install the cable ends on the cables. Screw the
end of the cable into the cable joint a mini-
mum of 8mm (0.3mm) and lock it with the
lock nut.
M
WARNING
I f the cable is not screwed in at least 8mm, the
cable joint could break. T his could cause loss of
control and an accident.
N O T E : If the cable end is fitted to the pin marked
with "R," the shift cable will not move smoothly.
9. Adjust the throttle cable end and fit it to the
pin marked "M" on the accelerator arm.
N O T E : Do not fit the cable end to the pin marked
with "R" on the accelerator arm.
10. Reconnect the white and black stop switch
leads (see "Removal," step 2) and reinstall
the CDI cover.
Installing the Control Handle
1. Select a location near the steering wheel or
S H I F T C A B L E
2. Install the control handle using a strong
3. Route the 2m cables so they do not have any
4. If the control handle is mounted on a tiller
T H R O T T L E
C A B L E
6-5
T9.9 Remote Tiller Rigging Kit
tiller handle for the control handle. Be sure
there will be easy access to the stop switch
and shift lever, and that the throttle operation
will not be hindered.
bracket which will firmly hold the handle in
place.
sharp bends. The minimum radius should be
16 inches. Make sure the cables are not under
any strain.
handle, care should be taken that the cables
are not strained or pinched during tiller
movement.