Yamaha T8 Rigging Manual page 228

Outboard Rigging Guide - 2001
i. Place the plain washer around the boss of
the control lever and fasten it with the
screws and washers.
Tightening Torque:
30 ~ 45 cm-kg
j. Install the shaft button in the hole in the
accelerator shaft and install the free accel-
erator button.
k. Turn the adjusting screw into the remote
control box through the hole in the cover.
1 Shaft Button
2 Free Accelerator Button
705 Flush Side Mount Remote Control Ass'y.
Connecting the Remote Control
Cable to the Engine and Fixing the
Remote Control Box to the Hull
1. According to the instructions given in the
respective owner's manuals of outboard
motors, connect the remote control cables
both for shifting and throttle and wire harness
to the engine. When connecting, set the con-
trol lever to Neutral.
2. Operate the control lever a few times and
check to see that the lever is turned to
Forward or Reverse until it stops the gear
shift once (about 35°). When the lever is
turned further from this position to Forward,
the throttle fully opens. Next, make sure that
when the control lever is returned to Neutral,
the throttle is completely closed. If not fully
closed, adjust the positions of cable joints, on
the engine side, and install them again.
NOTE: The cable joints (on the engine side)
must be screwed in at least 8mm (03 in) over the
remote control cables.
4-41