SEP 2005
3.1
PRECAUTIONS AND WARNINGS
The Analyzer electronics and GC Controller, when housed inside a purged enclosure meet the
certifications and classifications identified in Section 2.3.1.6, this manual. Emerson Process
Management does not, however, accept any responsibility for installations of these, or any
attached equipment, in which the installation or operation thereof has been performed in a
manner that is negligent and/or non-compliant with applicable safety requirements.
EQUIPMENT DAMAGE OR PERSONAL INJURY
The responsible body shall operate the equipment as designed and specified by the
manufacturer.
Failure to do so may cause personal injury or damage to the equipment.
3.1.1
Hazardous Environments
3-4
Observe Precautions and Warnings
1
Plan Site Location
2
Obtain Supplies and Tools
3
Install Analyzer Wiring
4
MODEL 1000
INSTALLATION AND SETUP