Supplemental Wiring Guide - Serial Communications; Gc Serial Port And Cable Configurations For - Emerson Daniel Danalyzer 1000 Hardware Reference Manual

SEP 2005
A.1 GC SERIAL PORT AND CABLE CONFIGURATIONS FOR RS-232
This section provides more detailed information about the serial port connections of the GC
Controller. It identifies serial port pin assignments and diagrams for designing RS-232 serial cables,
if that is necessary for your application.
GC Serial Ports are found on the GC Controller's Terminal Board for Field Wiring, and the
connection points for external devices are as follows:
Table A-1. Serial Ports on the Terminal Board for Field Wiring, GC Controller
Serial Port 1 (COM1)
Serial Port 2 (COM2)
Serial Port 3 (COM3)
Serial Port 4 (COM4)
Serial Port 5 (COM5)
Serial Port 6 (COM6)
Serial Port 7 (COM7)
Phoenix plug (bare-wire) connections are available to all four serial ports:
Pin-outs are identical for all four serial port Phoenix plugs and jacks. Each Phoenix plug /
jack (male) combination allows bare-wire connection and uses 9 pins as illustrated:
Figure A-1. Phoenix Connector (J5, J6, J10, and J11) Pinout
A-2
DB-9 plug connection
P2
P3
P22
P23
P24

SUPPLEMENTAL WIRING GUIDE - SERIAL COMMUNICATIONS

Phoenix plug (bare-wire) connection
-
-
MODEL 1000
J5
J6
J10
J11
-
-
-