Analog I/O Wiring - Emerson Daniel Danalyzer 1000 Hardware Reference Manual

SEP 2005
3.4.7

Analog I/O Wiring

To connect analog signal input/output lines to the GC Controller, follow these steps:
(1) Access the GC Controller's Terminal Board for Field Wiring (TB).
(2) Route analog I/O lines appropriately. Refer to drawing DE-20782.
(3) Make analog I/O connections to the GC Controller TB. In standard configuration, there are
connections for four analog input and two analog output lines, as follows:
(a) Analog Inputs -
Analog Outputs -
(b) For specific pin number assignments, see drawing DE-20782, GC Controller
drawings addendum, this manual.
3-86
Install Analyzer Wiring
4
Install Analyzer Sample & Gas Lines
5
Install GC Controller Wiring
6
Perform Leak Checks
7
GC Controller TB, connection port "J12"
GC Controller TB, connection port "J14"
- See NOTE, next page -
MODEL 1000
INSTALLATION AND SETUP