Cpu Rs-422 Configuration - Emerson Daniel Danalyzer 1000 Hardware Reference Manual

MODEL 1000
SEP 2005
3.4.4.3

CPU RS-422 Configuration

CPU COM1 RS-422 Configuration
RS-422 signal levels are supported on any, or all serial channels, with the installation of the optional
"Chip Kit" (P/N 3-2350-115). This kit provides the driver IC's necessary for a single channel of
RS-422. If two channels of RS-422 are required then two kits will be needed. RS-422 is a 4-wire
point-to-point full-duplex interface allowing much longer cable runs than are possible than with
RS-232. The differential transmitter and receiver twisted-pairs offer a higher degree of noise
immunity. The following illustrations show the correct jumpering, driver IC installation and I/O
connector pin definitions for each of the COM1 channels when used in RS-422 mode.
Figure 3-14. COM1 DB9 RS-422
3-53
INSTALLATION AND SETUP