Cpu Com1/Com2, Keyboard And Printer Output Header; Cpu Com3/Com4 Output Header - Emerson Daniel Danalyzer 1000 Hardware Reference Manual

MODEL 1000
3.4.4.5

CPU COM1/COM2, Keyboard and Printer Output Header

COM1, COM2, the keyboard, and the printer are terminated at J1. Refer to the Multi-I/O Connector,
Section 3.4.4.14 and Figure 3-34 for additional information.
3.4.4.6

CPU COM3/COM4 Output Header

COM3 and COM4 can be configured two different ways. To configure a system WITHOUT a
keyboard and display, connect cable (P/N 3-2350-084) from CPU J6 to the System Interface Board
J8 and J10. This provides access to COM3 on J10 and COM4 on J11 of the Field Termination
Board. The serial port setup in the MON2000 Software for COM4 must be selected as a PC port.
For a system WITH a keyboard and display, connect cable (P/N 3-2350-087) from CPU J6 to the
System Interface J8 and J12. This provides access to COM3 on J10 and COM4 is dedicated for use
as a serial interface to the keyboard and display. COM4 will not be available at J11 of the Field
Termination Board. The serial port setup in the MON2000 Software for COM4 must be selected as
Front Panel.
INSTALLATION AND SETUP
Figure 3-22. COM3-4 Output Header
SEP 2005
3-59