Subsequent Log-On - Emerson Daniel Danalyzer 1000 Hardware Reference Manual

SEP 2005
4.2.2

Subsequent Log-On

For subsequent log-on, follow these steps:
(1) If screen-saver mode is active (i.e., the screen's backlight is turned off and "Emerson" is
written on the screen in various locations), then press any key on the keypad and wait 10
seconds for contrast and backlighting to take effect.
(2) Press the ENTER key. A screen similar to the following should be displayed (see Figure 4-
3).
Emerson
Gas Chromatograph
Detector 1 > Idle
Run:
Enter PIN :
MON2000 May 16 07:09:10 1994
Figure 4-3. Press the ENTER key, then enter Username / PIN
If the "Enter PIN:
ENTER key; press the ESC key, and then press the ENTER key again.
(3) Enter your Username (and Personal Identification Number (PIN) if necessary), and then press
the ENTER key. If you have a PIN number assigned, you only have to enter the PIN. This
allows the Main Menu to be shown on the screen (see Section 4.3.1, this manual, for
illustration).
(4) From the Main Menu, press the number of the menu desired, or use the DOWN or UP
ARROW keys to highlight the menu desired, then press the ENTER key.
4-8
Model 2350A
Stream # : 0
0 Anly: 235
x" prompt does not remain displayed after you pressed the
OPERATION FROM LOCAL KEYPAD AND DISPLAY
Cyc: 240
x
Alarm: unackd
MODEL 1000