Basic 2350A Configuration - Emerson Daniel Danalyzer 1000 Hardware Reference Manual

MODEL 1000
F.3

BASIC 2350A CONFIGURATION

At this point, install, if any, all mounting hardware and optional PC/104 boards onto the 2350A CPU
Board.
(1) Install the 2350A CPU (P/N 3-2350-090) into slot 3 of the card cage assembly.
(2) Install cables on the CPU Board in the following sequence:
(a) Digital I/O cable (P/N 3-2350-081) from CPU J7 to the System Interface Board J2.
(b) Digital I/O cable (P/N 3-2350-080) from CPU J4 to the System Interface Board J3.
(c) COM1, COM2, and the printer cable (P/N 3-2350-083) from CPU J1 to the System
Interface Board J4, J9, and J11.
d) COM3 and COM4 can be configured two different ways. To configure a system
WITHOUT a keyboard and display, connect cable (P/N 3-2350-084) from CPU J6
to the System Interface Board J8 and J10. This provides access to COM3 on J10 and
COM4 on J11 of the Field Termination Board.
MON2000 Software for COM4 must be selected as a PC port.
(e) For a system WITH a keyboard and display, connect cable (P/N 3-2350-087) from
CPU J6 to the System Interface J8 and J12. This provides access to COM3 on J10
and COM4 is dedicated for use as a serial interface to the keyboard and display.
COM4 will not be available at J11 of the Field Termination Board. The serial port
setup in the MON2000 Software for COM4 must be selected as Front Panel. See
Figure F-5a.
If all four serial ports are required for communications on a system with keyboard
and display, an optional COM4A Board must be installed and a COM7 and COM8
cable (P/N 3-2350-086) connected (see Section 4.0 below). The serial port setup in
the MON2000 Software for COM8 must be configured as Front Panel. See Figure
F-5b.
(f) Reinstall the Analog cable to J6 on the System Interface Board.
2350 to 2350A CPU RETROFIT INSTRUCTIONS
The serial port setup in the
SEP 2005
F-9