Load All Default Settings; Updating Software; Update Via Xmodem - ADTRAN MX2800 M13 User Manual

Section 3, Configuration

Load All Default Settings

This option defaults all settings for the unit. Once the settings have been successfully retrieved, Command
Accepted will appear at the bottom of the screen
The User Account Management table is also reset to default.

Updating Software

Select
Update Flash Software
or TFTP.
Before beginning update of Flash software, disable the Auto Save feature
of the MX2800. From the
Management

Update Via XModem

Updating the Flash Software via XModem requires that a VT100 terminal menu session be active through
the units craft port. To update the software via XModem, follow these steps:
1. From the MX2800 Main Menu, select
then
Update via XModem
2. Once it has been determined where the new binary file is located, select
3. Once has been selected, start the XModem transfer from the terminal menu program that is being
Start
used by selecting or typing the file path for the location of the new binary file. Refer to the appropriate
documentation for the terminal emulator to begin XModem transfer.
4. After the binary file has been selected, the XModem transfer will begin. To cancel a transfer in
progress, press
C
TRL
XModem transfer. The
5. If updating a unit with redundant controller cards, the active controller will begin uploading the new
code to the standby controller after the XModem transfer has completed and the unit has successfully
loaded and programmed the new software into its Flash memory. If the unit does not have redundant
controller cards, go to
6. While the standby card is having code uploaded, the
amber. After the code has finished uploading to the standby card, the card will reset itself and begin
running the new code.
3-40
CAUTION
from the Utilities menu to update software, using either XModem protocol
Configuration
, then select
Auto Save
Configuration
.
three times. The
+X ACT
LED on the standby card is flashing green.
ACT
Step 7.
MX2800 M13 Multiplexer User Manual
NOTE
menu, choose
and toggle until it is set to
, then , then
Utilities
LED on the active card is solid amber for the duration of
LED on the standby card will be solid
ACT
System
.
Disable
Update Flash Software
to begin the transfer.
Start
61200290L1-1G
, and