Rackmount Installation - ADTRAN MX2800 M13 User Manual

Section 2, Installation and Operation
6. A readily accessible disconnect device that is suitably approved and rated must be incorporated in the
field wiring.
7. The chassis should be connected to an earth ground using the ground stud located between the AC and
DC power sources on the rear panel.
8. The unit must be installed in accordance with the requirements of NEC NFPA 70.
9. The unit must be installed in accordance with Articles 400 and 364.8 of the National Electrical Code
NFPA 70 when installed outside of a Restricted Access Location (i.e., Central Office, behind a locked
door, service personnel area only).
10. Care should be taken not to upset the stability of the equipment rack after installation is complete.
Use copper conductors only for DC power and ground connection.
5.

RACKMOUNT INSTALLATION

The MX2800 can be mounted into a standard 19-inch or 23-inch equipment rack. Follow these steps to
mount the unit into a rack:
1. Install the mounting flanges on each side of the MX2800 at one of the three available positions.
Be sure to install the flanges with the screws provided.
2. After the flanges have been installed, position the MX2800 at the correct location within the rack and
secure the mounting flanges to the mounting rails of the rack.
3. Make all network, DTE, and power connections to the rear of the unit. Refer to
for more information on making the DC power connection.
4. Using the 8-position modular to DB-9 female connector and the 8-pin to 8-pin modular cable, connect
a VT100 terminal device to the
Two MX2800s can be stacked with out any spacing between the units.
ADTRAN recommends 1U (1.75") of separation above and below the
two stacked units. This spacing allows the units to dissipate heat. The
design of the MX2800 uses the chassis to distribute heat generated by the
unit's internal cards. This design allows the units to operate without a
cooling fan, thus increasing overall reliability of the units.
2-4
CAUTION
CAUTION
port on the front panel of the unit.
CRAFT
NOTE
MX2800 M13 Multiplexer User Manual
Power Up on page 2-2
61200290L1-1G