MX2800 M13 Multiplexer User Manual
The MX2800 specifically uses quoted line(s) in
message has the following quoted line format:
REPT-ALM
<aid>:<ntfcncde>,<condtype>,<srveff>,<ocrdat>,<ocrtm>,<locn>...
The
field contains one of the following values:
NTFCNCDE
• CL indicates alarm cleared.
• TC indicates transient condition.
• MN indicates minor.
• MJ indicates major.
• CR indicates critical.
The
message has the following quoted line format:
REPT-EVT
<aid>:<ntfcncde>,<condeff>,<srveff>,<ocrdat>,<ocrtm>,<locn>...
The CONDEFF field will contain one of the following values:
• CL indicates standing condition cleared.
• SC indicates standing condition raised.
• TC indicates transient condition.
For possible CONDTYPE codes for both REPT-ALM and REPT-EVT quoted lines, see the condition types
listed in
Table 9-3
on page 9-12 and
Refer to the section
TL1 Autonomous Messages
supported by the MX2800.
4.
TL1 COMMANDS
As stated in
TL1 Messages
<verb>[-<mod1>[-<mod2>]]:<tid>:<aid>:<ctag>:<general block>:<keyword
block>: <state block>;
Areas of concentration for TL1 support in the MX2800 include session initiation, session termination, and
system event reporting.
The Target ID (
page 3-36.
61200290L1-1G
Table 9-4
on page 9-3, the general format for a TL1 command is as follows:
Table 9-2
lists the commands currently supported by the MX2800.
) is the same as the Unit ID. Refer to the
tid
Transaction Language 1 (TL1), Section 9
and
REPT-ALM
REPT-EVT
on page 9-16, respectively.
on page 9-11 for a list of Autonomous messages currently
NOTE
Autonomous messages. The
Unit ID
on
9-5