Power Up - ADTRAN MX2800 M13 User Manual

Section 2, Installation and Operation
MIB files are available from ADTRAN in the support section of the
ADTRAN Web page at www.adtran.com.
4.

POWER UP

The AC version of the MX2800 is provided with a 6-foot power cable terminated in a three-prong plug
which is connected to a grounded 120 VAC power receptacle.
Power to the AC version of the MX2800 must be provided from a
grounded 120 VAC power receptacle.
The DC version of the MX2800 is provided with two 4-position modular terminal lug connectors. These
connectors simplify the initial wiring and connection or disconnection of the DC power when replacing
rackmount units.
A 3-amp fuse is recommended for use in the fuse and alarm panel that
feeds the MX2800.
For more detailed information on power connections, refer to
Once the modular connector is wired, push it firmly into one of the rear panel power connectors.
2-1 on page 2-3 and Table 2-1
four connector symbols.
The chassis should be connected to an earth ground using the ground stud
located between the AC and DC power sources on the rear panel.
2-2
NOTE
NOTE
NOTE
on page 2-3 illustrate the DC power connector and give definitions for the
NOTE
MX2800 M13 Multiplexer User Manual
Section 8, Power Loss Recovery.
Figure
61200290L1-1G