Establishing Terminal Connection; Main Menu - ADTRAN MX2800 M13 User Manual

MX2800 M13 Multiplexer User Manual

Establishing Terminal Connection

A Telnet menu session has priority over a terminal menu session through
the craft port. If a terminal menu session is active when a
session is initiated, the terminal menu session will be disabled while the
menu session is active.
Telnet
To connect the MX2800 to a VT100 terminal, follow this procedure:
1. Configure the VT100 terminal for 9600, 19200, 38400, or 57600 baud, 8-bit characters, no parity, and
one stop bit (xxxx, 8N1).
2. Using the ADTRAN-provided terminal interface cable adapter, connect the DTE port of a terminal to
the 8-pin modular jack labeled
3. Initialize the terminal session.
4. Press repeatedly until the username prompt appears.
E
NTER
5. Enter the username. The factory default username is adtran. The password prompt appears.
6. Enter the password. The factory default password is adtran. The Main Menu appears. See
2-5 on page 2-10.

Main Menu

Make selections on the Main Menu by entering the number corresponding to the chosen parameter or the
desired key strokes. Refer to
A new Telnet session may take priority over an existing one if a username
and password are provided that have ADMIN privileges
61200290L1-1G
NOTE
on the MX2800 front panel.
CRAFT
Navigating Within the Menus
NOTE
Installation and Operation, Section 2
Telnet
on page 2-10
menu
Figure
2-9