Provisioning The Ds1 Ports - ADTRAN MX2800 M13 User Manual

Appendix A, Acceptance Test Procedure
• = M12(4xT1)
DS2 #6
• = M12(4xT1)
DS2 #7
For additional information about the previous configuration, refer to
Network Interface
2. Press the key to get back to the main
E
SC

Provisioning the DS1 Ports

1. From the main Configuration menu, select
should appear. Since there are 28 DS1 ports to configure and all of them need to be set identically dur-
ing acceptance testing, the Set Multiple provisioning feature of the MX2800 is used during this step.
To use the
Set Multiple
screen, confirm that
Set Multiple
to toggle the
State State
set all 28 DS1s to that mode. Press
2. Select . If all channels are set to
T1/E1 State
Configure T1/E1 Interface
referenced above.
3. Select
T1/E1 Line Coding
Configure T1/E1 Interface
accordingly.
4. Select
T1/E1 Line length
) as appropriate for the installation, proceed to the next step. If not, perform the
655 feet
routine accordingly.
5. Select
T1/E1Loopback Detection
6. Select . Set
Set Multiple
7. Press twice to return to the
E
SC
8. Select
T1/Circuit Protection
9. Select . Set
Set Multiple
.
Settings
10. Press once and select
E
SC
Configure T1/E1 Interface menu.
11. Select
XCV Threshold
12. Press the key to get back to the main Configuration menu.
Esc
A-4
on page 3-4.
Configuration
T1/E1 Interface
feature, select the attribute from the
and
First = 1
as necessary until the correct setting is displayed, and select
twice to return to the
E
SC
Auto Enable
menu and proceed to the next step. If not, perform the
. If all channels are set to
menu and proceed to the next step. If not, perform the
. If all channels are set correctly (
.
to , to ,
First 1 Last 28 Loopback Detection
Configure T1/E1 Interface
.
to and to
First 1 Last 28
Protection Threshold
. Select .
Disabled
MX2800 M13 Multiplexer User Manual
NOTE
menu.
. The Configure T1/E1 Interface menu
Configure T1/E1 Interface
. If not, make the necessary corrections. Select
Last = 28
Configure T1/E1 Interface
(default), press
(default), press
B8ZS
,
0-133 133-266
to
Disabled. Select Apply Settings
menu.
. Set
Circuit Protection
. Enter a value of 1 and press
screen. From the
Apply settings
menu.
to get back to the
E
SC
Set Multiple
to get back to the
E
SC
Set Multiple
, , or
266-399 399-533
Set Multiple
to . Select
Enabled Apply
once to return to the
E
SC
61200290L1-1G
to
routine
routine
533-
.