Read Community Name - ADTRAN MX2800 M13 User Manual

Section 3, Configuration
Trap
Comn Eqpt Fail NSA
DS2 Alarm Traps
OOF
AIS
RAI
Local T1/E1 Alarm Traps
LOS
carrier side AIS
(CAIS)
loop side AIS (LAIS)
XCV
T1/E1 Failure
In/Out Test
Far-End Alarms (available only in C-Bit Parity mode)
Multiple DS1 LOS
Single DS1 LOS
DS1 Eqpt Fail SA
DS1 Eqpt Fail NSA
MIB II Standard Alarm Traps
Cold Start
Link Up
Link Down
Authentication Fail-
ure

Read Community Name

This field is used to enter the authentication strings used for SNMP management. Match the MX2800 to
the SNMP manager for read privileges.
3-24
Table 3-3. Trap Descriptions (Continued)
If enabled, the unit issues a trap when...
The remote unit's active controller card is receiving a common equipment failure mes-
sage from the network.
The DS2 detects a framing loss from the network.
The DS2 is receiving an AIS (blue) alarm condition from the network. AIS alarms occur
when the unit is receiving unframed all ones.
The DS2 is receiving an RAI (yellow) alarm from the network. This alarm is a signal sent
back toward the source of a failed transmit circuit. The X-bit is set to zero.
The unit has lost the Rx signal on a T1/E1.
The T1 is receiving all ones from the DS3 side of the network.
The T1 is receiving all ones from the DSX-1 interface.
The unit is receiving excessive code violations across a T1/E1, exceeding the configured
threshold. For more information, refer to
A T1/E1 has failed.
A T1/E1 is going in or out of test.
The far-end equipment has lost multiple T1/E1 lines.
The far-end equipment has lost a single T1/E1.
A service-affecting equipment failure is being reported by the far-end.
A non-service-affecting equipment failure is being reported by the far-end.
The unit is first powered up.
The DS3 is up with no alarms.
The DS3 is in alarm.
An attempt has been made by an unauthorized user to access the unit.
MX2800 M13 Multiplexer User Manual
XCV Threshold on page 3-15.
61200290L1-1G