Performing A Functional Test; Connection To The Control (Indraworks) - Bosch rexroth HS5E Instruction Manual

Commissioning | A4... with HS5E(V)(L) control system Series 1x and 30
8.1.3 Performing a functional test
Improperly connected axial piston unit!
Mixing up the ports will cause malfunctions (e.g. lift instead of lower) and could
present a hazard to personnel and equipment!
▶ Before the functional test, check whether the piping specified in the hydraulic
circuit diagram has been installed.
Once you have tested the hydraulic fluid supply, perform a functional test of
the machine/system. The functional test should be performed according to the
specifications of the machine/system manufacturer.
The axial piston unit is tested for functional capability and performance before
delivery according to the technical data. During commissioning, make sure the axial
piston unit was installed in the machine/system as intended.
▶ After starting the drive motor, check in particular the specified pressures,
e.g. working pressure and case pressure.
▶ Perform a leak test without and with load prior to normal operation.
▶ If necessary, remove the pressure gauge and plug the ports with the specified
threaded plugs.

8.1.4 Connection to the control (IndraWorks)

We will assume that IndraWorks has already been installed. If this is not the case,
install IndraWorks as described in manual R911344285. After this, you must connect
the HS5E pilot control valve to the PC's Ethernet port and modify the (TCP/IPv4) IP
address of the network port to match the IP address range of the HS5E pilot control
valve. The default address of the HS5E pilot control valve is 192.168.0.1. If the IP
address is incorrect, the row is highlighted in red. After you have configured the
network port, you can open IndraWorks and start a network search:
WARNING
RE 92076-01-B/2021-04-22, Bosch Rexroth AG
67/104