After 'ModuleREADY' (Un\G34, b0) is detected to be on, the initial value is set to the MI object, and 'BACnetStartupRequest' (Un\G37, b1) is turned on.

(14) The program writes 0: Operational to 'SystemStatus' (Un\G8500).

(30) The value for the analog output is read from the AnalogOutput object and the read value is set to the required setting value in "Units".

(62) The value for the analog output is written to PresentValue of the AnalogOutput object.

(90) The setting value related to the analog output is read from the AnalogValue object.

(99) The ON/OFF status is read from the BinaryOutput object and the read status is output. Then, the output result is stored in FeedbackValue.

(121) The parameter data is read from the Multi-state Output object and the read data is set to an external device. Then, the setting result is read and stored in

FeedbackValue.

7 PROGRAMMING

7.3 Program Examples

Table of Contents