Mitsubishi Electric MELSEC iQ-F Series User Manual page 28

Setting using a program
This section describes the program settings for each object.
Writing values to the buffer memory using a program changes the property value of the Ethernet module.
For the program settings for the Accumulator object, refer to the following.
Page 32 Setting using a program
■Writing from the program and reading from a BACnet workstation or BACnet controllers
Property value
(1) Write a value to the buffer memory using the program.
(2) The Ethernet module uses the value in the buffer memory as a property value.
■Writing from the program and a BACnet workstation or BACnet controllers
Property value
(1) When a value is written from the program, the program writes the value to the buffer memory.
(2) When a value is written from a BACnet workstation or BACnet controllers, the Ethernet module writes the value to the buffer memory.
Precautions
When values are written from the program and the Ethernet module at almost the same time, the value written later is set as
the property value.
4 FUNCTIONS
26
4.2 BACnet Object Function
1
(1)
0
Writing data from the program
1
(1)
0
(2)
0
Writing data from BACnet
workstation or another BACnet
controller
1
0
(2)
1