Networkport (Np) Object - Mitsubishi Electric MELSEC iQ-F Series User Manual

NetworkPort (NP) object

This object handles the communication port.
Property list
The following table lists available properties for the NetworkPort object.
Additionally, the availability of reading/writing data from/to a BACnet device is shown in the following table.
R: Read-only, W: Read/Write
*1
PropertyID Property
75 ObjectIdentifier
77 ObjectName
79 ObjectType
81 OutOfService
103 Reliability
111 StatusFlags
371 PropertyList
399 APDULength
400 IPAddress
401 IPDefaultGateway
406 IPDNSServer
408 BACnetIPMode
411 IPSubnetMask
412 BACnetIPUDPPort
416 ChangesPending
420 LinkSpeed
423 MACAddress
425 NetworkNumber
426 NetworkNumberQuality
427 NetworkType
482 ProtocolLevel
*1 Only ANSI/ASHRAE Standard 135-2016 is supported.
Data type
BACnetObjectIdentifier
CharacterString
Enumerated
BOOLEAN
Enumerated
BitString
BACnetARRAY[N]ofBACnetPropertyIdenti
fier
Unsigned
OCTET STRING
OCTET STRING
BACnetARRAY[N] of OCTET STRING
ENUMERATED
OCTET STRING
Unsigned16
BOOLEAN
REAL
OCTET STRING
Unsigned16
ENUMERATED
ENUMERATED
ENUMERATED
R/W Description
R Indicates the ID to identify the object.
R Indicates the object name.
R Indicates the object type.
R Indicates whether the device is
disconnected from the physical input.
R Indicates reliability.
R Indicates the object status.
R Indicates the property list.
R Indicates the maximum number of octets
contained in a single non-splittable
application protocol data module sent or
received on this port.
The Ethernet module is 1024.
R Indicates the IP address.
R Indicates the default gateway.
R Indicates the DNS server.
The Ethernet module does not support it.
R Indicates the BACnet/IP mode of the
network port. (This Ethernet module is
NormalDevice.)
R Indicates the subnet mask.
R Indicates the UDP port number.
R Indicates whether the configuration
settings of the network port object are
mapped to the current configuration
settings. When the value is FALSE, the
current port configuration information is
reflected in the configuration settings.
When the value is TRUE, it indicates that
the configuration setting has been
changed but not activated on the port.
The Ethernet module is fixed to FALSE.
R Indicates the network communication
speed in bits per second. When the value
is 0, it indicates an unknown
communication speed.
The Ethernet module is fixed to 0.
R Indicates a 6-octet combination of
IPAddress and BACnetIPUDPPort.
W Indicates the network number.
R When NetworkNumber is 0, it indicates
UNKNOWN.
When NetworkNumber is not 0, it indicates
CONFIGURED.
R Indicates the network type (IPv4).
R Indicates the protocol used
(BACNETAPPLICATION).
4 FUNCTIONS
4.2 BACnet Object Function
4
43