Chapter 6 Parameter Settings; Setting Parameters; Required Settings - Mitsubishi Electric MELSEC iQ-F Series User Manual

6
PARAMETER SETTINGS
This chapter describes the parameter settings required to perform BACnet communications using the Ethernet module.
6.1

Setting Parameters

1.
Add the "Information Module (FX5-ENET, FX5-ENET/IP)" to the engineering tool.
Navigation window  [Parameter]  [Module Information]  Right-click  [Add New Module]
2.
The required settings, basic settings, and application settings are included in the parameter settings. Select one of the
settings from the tree on the following window.
Navigation window  [Parameter]  [Module Information]  Target module
3.
After setting the parameters, click the [Apply] button.
4.
Write the parameter settings to the FX5 CPU module with the engineering tool.
[Online]  [Write to PLC]
5.
The parameter settings are applied by resetting the FX5 CPU module or powering off and on the system.
6.2

Required Settings

Set the operation mode of the Ethernet module.
For details, refer to the following.
 MELSEC iQ-F FX5-ENET User's Manual
 MELSEC iQ-F FX5-ENET/IP User's Manual
6 PARAMETER SETTINGS
6.1 Setting Parameters
6
51