Operating System Software Verification; System Reset; Keyboard Control; Non-Menu Programming - American Dynamics AD2052 System Programming Manual

Operating System Software Verification

When calling American Dynamics for assistance, the revision
level of the 2052CPM software may require verification.
To verify the 2052CPM operating system software:
1. Turn the keyswitch on the keyboard to the PROG position.
2. Enter the following keyboard F2 code combinations:
"70 F2" (Enter the number 70, then press the F2 key.)
Note: Operating System software verification is accessible
from 1678CM or 2078 keyboards only.
In response, a 5-digit code, "UFna n", is shown in the Status
Line of the on-screen display (Figure 2-1, page 2-2). The last
digit of this display code is a number which identifies the
revision level of the 2052CPM Operating System.

System Reset

It may be necessary to clear all programmed information from
the 2052, and reset the system to factory defaults.
CAUTION - THE FOLLOWING COMMANDS ERASE
ALL USER ENTERED DATA.
To clear and reset all 2052 programming (to factory defaults):
1. Turn the keyswitch on the keyboard to the PROG position.
2. Enter the following keyboard F2 code combinations:
"55 F2" (Enter the number 55, then press the F2 key.)
"99 F2" (Enter the number 99, then press the F2 key.)
Note: System Reset is accessible from 1678CM or 2078
keyboards only.
When this combination of keys is entered, the 2052 system
clears and resets all user programmed functions (Tours, Salvos,
Alarm Programming, Event Timers, etc.). System Reset resets
the 2052 programmed functions to the factory default settings.
Note: A built-in safety feature requires entering the "99 F2"
command within three seconds of the "55 F2" command.
If "99" is not entered within the required three seconds, the
system will not clear and reset.
Keyboard Control (Section 2)
Standard 2052 system operating capabilities are provided from
any American Dynamics keyboard. These system operations
are "monitor oriented" in that a keyboard controls only those
functions associated with the monitor and camera under
control of the keyboard. Keyboard control functions are:
• Video Selection - Monitor and Camera
• Controlling Site Camera (P/T/L)
• Activating Presets and Auxiliaries
• Running Tours
• Calling Salvos
• Acknowledging Alarms
Non-Menu Programming (Section 3)
Non-menu programming is provided for many 2052 system
setup functions. As a security feature, the 1678CM and 2078
keyboards have a keyswitch for disabling these non-menu
system setup functions. Non-menu setup functions are:
• System Reset
• Programming Preset Scenes
• On-screen Display Arrangement
• Setting Date and Time
• Setting Camera Video Loss Detection
• Monitor Tour Programming
• Alarm Programming
Menu Programming (Section 4)
Menu-driven programming is provided for most 2052 system
setup functions. Setup security is provided by a keyswitch on
the 1678CM and 2078 keyboards which controls access to the
programming menus. Menu setup programming functions are:
• Setting Time and Date
• Programming System Tours and Salvos
• Programming Event Timers
• Programming Alarm Contact Tables
• Establishing Status and Arming of Monitors
• Assigning Pseudo Camera Numbers
• Assigning Camera Titles
• Establishing RS-232 Ports usage
• Establishing Keyboard, Monitor, and Camera Access
• Establishing User and Keyboard Priorities
IF YOU ENCOUNTER ANY PROBLEMS
OPERATING THIS UNIT, OR NEED ASSISTANCE,
CALL OUR TECHNICAL SUPPORT CENTER:
within the United States: 1-800-442-2225
outside the United States: (914) 624-7640
1-3