Camera Title - American Dynamics AD2052 System Programming Manual

TITLE
The Camera TITLE menu permits programming a 16-character
alphanumeric title for each camera for its on-screen display.
This menu also allows selection of the video loss detection
mode for each camera input, if a Video Loss Detector module
is present and setup for a port (see Ports menu, page 4-20).
CAMERA - 0001
VIDEO LOSS - OFF
TITLE -
AMERICAN
DYNAMICS
PREVIOUS MENU
To select a camera for programming:
1. Place the cursor at the CAMERA number line.
2. Press the ACK key to cycle through the available camera
numbers until the desired number is shown, then press the
NEXT key to move to the VIDEO LOSS or TITLE line.*
or
Enter the desired camera number on the keypad and press
the ACK key to select a specific camera and move the
cursor to the VIDEO LOSS or TITLE line. *
* The cursor moves to the VIDEO LOSS line only if a Video
Loss Detector module is present and set up to a port. If not,
the VIDEO LOSS line is not displayed and the cursor
moves to the TITLE section.
Note: Two cursors exist in the TITLE section of this menu.
One cursor indicates position in the title; the other indicates
the alphanumeric characters to be selected. The NEXT key
is used to move the cursor within the title. The joystick is
used to move the cursor within the selectable letters,
numbers, and symbols.
1 P S E U D O
2 T I T L E
(see * note below)
A B C D E F G H I J K L M N
O P Q R S T U V W X Y Z a b
c d e f g h i j k l m n o p
q r s t u v w x y z 0 1 2
3 4 5 6 7 8 9 < > : - . / ;
C A M E R A
R E T U R N M A I N
To select the camera video loss mode:
1. Place the cursor at the VIDEO LOSS line. This line is
displayed in the Camera Title menu only if a Video Loss
Detector module is present and setup to a port (page 4-20).
2. Enter the number of the desired video loss detection mode
on the keypad and press the ACK key to set the mode. The
mode selections are:
1 - OFF, loss detection disabled
2 - SYNC ONLY, sync loss detection enabled
3 - VIDEO LOW, sync and low picture content video
loss detection enabled
4 - VIDEO MED, sync and medium picture content
video loss detection enabled
5 - VIDEO HIGH, sync and high picture content video
loss detection enabled
or
Press the ACK key to cycle through the loss detection
modes. Press the NEXT key to save the selected mode.
The video loss detection mode may also be set by keyboard
actions (page 3-3).
To enter or edit the camera title:
1. Use the NEXT key to place the cursor at the TITLE lines.
2. To edit an existing title, use the NEXT key to move the
cursor within the title to the character to be changed.
Note: In order to change a character that has already been
programmed, begin from the first entry and proceed through
the text until the desired character location is reached. You
cannot backspace through the title.
3. Use the joystick to move the alphanumerics cursor to the
desired letter, number, or symbol.
4. Press the ACK key to acknowledge and place the selected
character within the title.
5. Repeat steps 2, 3, and 4 using the joystick and the ACK key
to "key-in" the desired title.
The PREVIOUS MENU line of the Title menu returns to the
CAMERA menu, page 4-18.
4-19
MENU PROGRAMMING