Monitor Menu - American Dynamics AD2052 System Programming Manual

MENU PROGRAMMING
MONITOR
The MONITOR menu is used to review and change each
monitor's setup programming.
To select a Monitor for review or programming:
1. Place the cursor on the MONITOR line.
2. Enter the monitor number (1 - 32) on the keypad and press
the ACK key to move to the ARM TYPE field.
ARM TYPE - The Arm Type indicates the current alarm
display, queuing, and removal method armed for this monitor.
The available monitor Arm Types are listed in the table to the
right. The default value for all monitors is DIS (Disarmed).
To set or change a monitor Arm Type:
1. Position the cursor to the ARM TYPE line.
2. Press the ACK key to cycle through the Arm Types until the
desired Arm Type is shown, then press the NEXT key.
or
Enter the code number for the desired Arm Type (see table)
and press the ACK key.
For arming codes 13 - 15, the second (Sequence) monitor is
selected automatically (the next numeric system monitor)
when the first (Hold) monitor is armed.
The cursor moves to the BLOCK number field (###) if a block
arming code is selected (7 - 12), and a new block number (the
next sequentially available block number, from 1 - 32) is
displayed. If a non-block arming code is selected the BLOCK
number defaults to a pound symbol (###) and the cursor moves
to the ACK field.
Note: ARM TYPE cannot be set or changed if any alarm
contacts are active.
M O N I TO R - 0 0 1
A R M T Y P E - # # #
TO U R - - -
D AT E / T I M E -
T I T L E D I S P L AY -
C A M T I T L E L C K -
M O N T I T L E L C K -
D I S P L AY S TAT U S -
R E T U R N M A I N
4-16
A C K -
Monitor Arming Codes
Code Description
1 Sequence, Instant Clear
2 Sequence, Auto Clear (after 20 seconds) SSA
3 Sequence, Manual Clear (ACK key)
4 Hold, Instant Clear
5 Hold, Auto Clear
6 Hold, Manual Clear
7 Block Sequence, Instant Clear
8 Block Sequence, Auto Clear
9 Block Sequence, Manual Clear
10 Block Hold, Instant Clear
11 Block Hold, Auto Clear
12 Block Hold, Manual Clear
13 Hold and Sequence,
Instant Clear
14 Hold and Sequence,
Auto Clear
15 Hold and Sequence,
Manual Clear
16 Disarmed
* Manual Clear/Acknowledge is always enabled.
The Manual Clear/Acknowledge feature can be enabled or
disabled for any Instant Clear and Auto Clear arming code via
the ACK entry of the Monitor menu. When enabled, the ACK
key can also be used to clear alarms from this monitor (see
Acknowledging Alarms, page 2-4).
The monitor arming code can also be set by keyboard
commands, page 3-6.
See the Appendix, pages A-3 to A-7, for further definition of
the Monitor Arming Codes.
Arm Type
SSI
SSM A*
SHI
SHA
SHM A*
BSI
BSA
BSM A*
BHI
BHA
BHM A*
First Monitor Second Mon
Arm Type Arm Type
DHI DSI
DHA DSA
DHM A* DSM A*
DIS