Keyboard/Camera View - American Dynamics AD2052 System Programming Manual

KEYBOARD/CAMERA VIEW

This menu defines the Keyboard-to-Camera viewing access,
which prevents selected keyboards from calling up selected
cameras for viewing on any monitor. (If you can't view the
camera you also can't control it.)
In this menu it is the keyboard which controls what can be
viewed on a monitor. The codes for each entry in the menu
are:
Y = keyboard has access privilege to view a camera
N = keyboard does not have access to view a camera
The Keyboard/Camera View menu has multiple pages with
eight cameras per page vertically, and eight keyboards per page
horizontally. Refer to page 4-3 for menu paging instructions.
K E Y B O A R D / C A M E R A V I E W
K E Y B O A R D S
C A M 0 1 0 2 0 3 0 4 0 5
0 0 0 1 Y Y
0 0 0 2 N N
0 0 0 3 Y Y
0 0 0 4 Y Y
0 0 0 5 Y Y
0 0 0 6 Y Y
0 0 0 7 Y Y
0 0 0 8 Y Y
P R E V I O U S M E N U
The above example menu indicates that:
• All keyboards have access to call camera 1.
• Keyboards 1, 2, and 3 can not call camera 2.
• Only keyboards 1, 2, and 3 can call camera 3.
1 . K E Y B O A R D / M O N I TO R
2 . K E Y B O A R D / C A M E R A V I E W
3 . K E Y B O A R D / C A M E R A C O N T R O L
4 . M O N I TO R / C A M E R A A C C E S S
5 . M O N I TO R / C O N TA C T A C C E S S
0 6 0 7
Y Y Y Y Y
N Y Y Y Y
Y N N N N
Y Y Y Y Y
Y Y Y Y Y
Y Y Y Y Y
Y Y Y Y Y
Y Y Y Y Y
A C C E S S
R E T U R N M A I N
The Keyboard/Camera View menu entries are set default to Y,
all keyboards have access privilege to to view all cameras.
To change the access to a selected camera from a keyboard:
1. Position the cursor to the camera and keyboard location that
is to be changed.
2. Press the ACK key. When the ACK key is pressed the
current setting toggles between Y = access, N = no access at
the cursor location.
3. Repeat steps 1 and 2 for any additional changes desired.
4. Position the cursor at the PREVIOUS MENU line.
5. Press the ACK key to return to the main ACCESS Menu.
Following programming by this menu, if the user attempts to
call a camera from a keyboard which has been set to no access
("N") for this camera, the message "NO CTRL" is displayed in
the on-screen video status line.
0 8
Y
This Camera View lockout also prevents specified keyboards
Y
from control access (page 4-24) to the same cameras.
N
Y
Note: Cameras that do not have viewing access from a
Y
keyboard should not be placed in a System Tour. If the
Y
keyboard calls a System Tour that contains a camera
Y
that is intended to be "locked out", it will be viewed
Y
during a System Tour.
4-23
MENU PROGRAMMING