Camera Setup - American Dynamics DV16000 Installation And Operating Instructions Manual

®
Intellex Digital Video Management System Installation and Operating Instructions

CAMERA SETUP

Camera Setup
The Camera Setup screens let you define the name and
termination settings for each camera. You must possess the Setup
Cameras privilege to access it (see
1. From the main screen, click the Setup button. The Setup
Options screen appears (see
2. Click the Cameras button. The Names screen (the first
Camera Setup screen) appears.
Use the Names screen to define the name of each camera. These
names are displayed when viewing live images and are stored in
the image database with recorded images.
1–16 — Use the mouse pointer to highlight one of the current
camera names. Then use the virtual keyboard or the physical
keyboard (if attached) to enter the new name, up to 10 characters.
The default names are Camera1 through Camera16.
Click OK to accept the new camera names, as well as any changes
on the other Camera Setup screen. Click Cancel to cancel the
changes. Click Help to display online help for this screen.
Since terminators are not required on Intellex units, use the
Termination screen to define each camera's setting, either 75
Ohms or Hi-Z. The default is 75 Ohms.
When set to 75 Ohms, the unit terminates the camera. This is the
same as installing a terminator on the associated Camera Out
connector.
When set to Hi-Z, the camera signal is passed through to the
associated Camera Out connector. This is the same as removing a
terminator and attaching a cable to the associated Camera Out
connector.
Click OK to accept the new termination settings, as well as any
changes on the other Camera Setup screen. Click Cancel to
cancel the changes. Click Help to display online help for this
screen.
Security Setup).
Setup Options Screen).
35
MORE>>>