Rear Panel Connectors - Teledyne Foxy R1 Instruction Manual

® ®
Foxy R1 and Foxy R2 Fraction Collectors
Section 1 Introduction

1.5 Rear Panel Connectors

Connectors
Connector
1-8
The rear panel connectors are used to power the fraction collector
and connect it to other devices.
Table 1-3 Rear Panel Connectors
Item Number
1
2
3
4
5
6
Table 1-4 Ethernet Connector Pins
Pin Type
1 Output/Input
2 Output/Input
3 Input/Output
4 Termination
5 Termination
6 Input/Output
7 Termination
8 Termination
Description
Ethernet 1 Connector (See Table 1-4)
Ethernet 2 Connector (Table 1-4)
Pump Connector (Table 1-5)
Detector Connector (Table 1-6)
RS-232 Serial Connector (Table 1-7)
AC Mains Power
Mains power must meet the voltage, fre-
quency, and amperage requirements
listed on the serial number label. Mains
power fluctuations must not exceed 10%
of the nominal supply voltage.
The mains power cord is the disconnect
device.
Description
TX+ / RX+ (auto MDI/MDIX)
TX– / RX– (auto MDI/MDIX)
RX+ / TX+ (auto MDI/MDIX)
RX– / TX– (auto MDI/MDIX)