Teledyne Foxy R1 Instruction Manual page 19

Foxy
Table 1-2 Specifications
Standard Diverter Drop former (NC): 110 µL
Valve Internal Volume: Waste (NO): 130 µL
Diverter Valve 25 psi (1.723 bar) maximum, standard and high
Inlet Pressure: flow valves
Peak Detection: Threshold level, peak width (slope detection), time
windows
System Control: Operator:
Front panel control via touch screen LCD
Integrated systems:
Direct communication via Ethernet (TCP/IP) and
RS-232 serial communications.
Stored Methods: Eight
Operating Voltage: 100–240 VAC, 50–60 Hz, 1 ampere maximum.
Mains voltage must not exceed 10% of the nomi-
nal supply voltage.
Operating 0 to 40 °C
Temperature: 32 to 104 °F
Humidity: 95% relative humidity maximum. Internal heaters
protect internal components.
Inputs: Pump counter
advance
Outputs: Pump pause
Wetted Materials: Valve: PEEK and Perfluoroelastomer (FFKM)
Supplied ferrules: ETFE
Supplied valve tubing: PTFE
Supplied drain tubing: Vinyl
Typical Applications: Prep-HPLC, peptide/protein purification, soil
extraction, density gradient fractionation.
Electrical Safety per EN 61010-1, Second Edition:
Maximum Altitude: 2000 meters
Pollution Degree: 2
Installation Category II
a. Teledyne Isco is continually improving its products therefore specifications
are subject to change.
b. No rack is required for R1 which holds 9 bottles on the drip tray. R2 re-
quires a set of two racks which hold a total of 18 bottles.
c. +3.3 to 5 VDC or contact closure, active low, 30 ms minimum, 5 VDC max.
d. 0 to 1.0 V nominal, –1.2 to +1.2 V usable, –5 to +5 V max.
e. Output is open collector, active low, 15 VDC/100 mA maximum
f. 300 millisecond output is open collector, active low, 15 VDC/100 mA max-
imum.
® ®
R1 and Foxy R2 Fraction Collectors
Section 1 Introduction
a
(Continued)
c c
, external peak , inject
c d
, analog peak voltage
e
, tube change event
c
, tube
.
f
.
1-7