Accessory Cable Specifications; Cables For Isco Accessories; Cable For Non-Isco Pumps - Teledyne Foxy R1 Instruction Manual

® ®
Foxy R1 and Foxy R2 Fraction Collectors
Section 1 Introduction
Table 1-7 RS-232 Serial Communication Connector Pins
Connector
1.6 Accessory Cable
Specifications
1.6.1 Cables for Isco
Accessories
1.6.2 Cable for non-Isco
Pumps
1-10
Pin Type
1 Not used
2 Output
3 Input
4 Reserved
5 Common
6 Reserved
7 Not used
8 Not used
9 Not used
K Shield
Cables are available to connect the fraction collector to Isco
equipment:
• To connect the fraction collector to a TRIS pump, order
accessory cable 69-2134-172. This cable connects the
Signal output from the TRIS pump to the fraction
collector's Pump connection. This cable carries the pump
count and pump pause signals.
• To connect the fraction collector to an Isco UV-Vis
detector such as the UA-6, order accessory cable
69-2134-173. This cable carries the analog peak detector
signal, as well as the tube advance, event pulse, external
peak, and inject signals.
A cable is available to connect the fraction collector to a non-Isco
pump. Part number 69-2134-170 is a six-foot long cable with one
end terminated as a 6-pin mini-DIN connector. The other end is
stripped and tinned for connection to the external device.
Description
TxD RS-232 serial data out
RxD RS-232 serial data in
Circuit common
Earth Ground