Gps Enable/Disable; Entering Gps Location Service - Motorola TETRA MTM800 Manual

GPS Enable/Disable

1. From the main menu, press
The current selection (On/Off) is highlighted. The display
shows:
On — Location Service On
Off — Location Service Off
2. Scroll to your selection and press
If GPS is enabled but the radio is not
synchronized to the GPS satellites the
following idle screen is displayed:

Entering GPS Location Service

To enter the GPS sub-menu, press
9 Location.
–
Position — provides the actual position
information.
Interface — allows you to enable/disable the GPS location
service.
This estimate of accuracy of the calculated location is only a
very rough estimate and may vary substantially from the
actual accuracy of the approximate location information
reported.
• The variation will vary in accordance to the GPS
Configuration set by your Service Provider.
• The availability of the GPS Location menus is dependent on
your terminal configuration, please contact your Service
Provider for further details.
Viewing Your Position (
1. From the main menu, press
2. This displays the following information about the last time
your location was calculated (if available):
UTC — The time the location was last calculated.
( 9 2)
– 9 Location – 2 Interface
(
9 1)
– 9 Location – 1 Position
.
1 Position
Range 1
No GPS signal
9)
1 Position
2 Interface
.
.
65