Making A Dmo Group Call (Ms To Ms); Making A Dmo Group Call Via Gateway - Motorola TETRA MTM800 Manual

keypad, and press
will blink upon selecting the gateway.
• "None", indicating that no gateway was
selected for that talkgroup. Enter an
address via the keypad, and press
The Gateway and Repeater icons will
blink upon selecting the gateway.
When the MTM800 detects the appropriate
gateway and/or the Repeater, the Gateway
and/or Repeater icons will turn solid,
respectively.

Making a DMO Group Call (MS to MS)

1. Press and hold
2. To change range and talkgroup, see steps
3 and 4 of "Making a Group Call" on
page 32.
3. If this is the desired talkgroup and range,
press the
permit" tone (if configured) and then speak
into the microphone. Release the
button to listen.
To change talkgroup and range, see the Group Mode section,
page 28.

Making a DMO Group Call via Gateway

1. While in DMO, choose a gateway as described in "Selecting
DMO Group Call via Gateway" on page 41.
2. Place the call for the selected talkgroup:
• If you press PTT while the gateway is not available, you
will start a DMO call without gateway. The Gateway icon
will disappear.
. The gateway and repeater icons
for a few seconds.
button. Wait for the "Talk
PTT
Selected GW:
None
.
DMO Range1
DMO TG1
Police
Rescue 1
Entering
Direct Mode
DMO Range1
DMO TG1
PTT
43