Motorola TETRA MTM800 Manual page 158

Receiving a Group Call with Scan Off
You can receive a group call from the selected talkgroup or
from the associated ATG only.
Receiving a Group Call in Idle Mode
In Automatic Mode Switch you can receive a
Group Call in any mode. Your MTM800 will
automatically switch into Group mode and
receive the transmission.
Receiving a Group Call during an On-going Group Call
Depending on how your Service Provider has configured
incoming calls, the incoming call will either be:
• Forced upon you and will interrupt the ongoing call (if the
incoming call has higher priority than the ongoing call).
or
• Presented to you (if it has higher priority
than the on-going call).
To accept the call, press
button.
PTT
Receiving a Group Call with Scan On
With Scan On, you can receive a group call from the scan list
you set up, in addition to receiving a group call from the
selected talkgroup or from the associated ATG.
Receiving the scan call functions as
receiving an associated ATG or selected call
in scan off (see previous page), except for
the following:
• The display is different when receiving the call in idle
mode, as shown here.
• The MTM800 sounds a tone as explained in the note
below.
When receiving a High Priority Group Call, your MTM800 will
sound a "High Priority Group Call" tone (if configured by your
Service Provider).
34
, and press the
Group In Use
TG 4
ID:124
Talkgroup 7
ID: 124
Talkgroup 7