Terminal Permanent Disable; Terminal Temporary Disable Or Enable; Wireless Application Protocol (Wap); Wap Browser - Motorola MTM800 FuG Feature User Manual

5.20

Terminal Permanent Disable

NOTICE: This feature is a selling feature.
Your radio is provided with a feature that allows your service provider to disable it permanently in case
it is stolen or lost. When your radio is disabled permanently, it becomes inoperable. After a Permanent
Disable your service provider cannot enable your radio. It is recommended to Permanent Disable your
radio only when you do not expect to recover it. If it is recovered then a Permanent Disable radio can
be reactivated by returning it to Motorola Solutions.
5.21

Terminal Temporary Disable or Enable

Your radio is provided with a feature that allows your service provider to disable it temporarily in case it
is stolen. When your radio is disabled or is powered up in disabled state, it looks and acts like it is
turned off.
If your radio is found, your service provider can enable it again over the air. After your radio is enabled,
you may resume normal operation.
5.22

Wireless Application Protocol (WAP)

NOTICE: This feature is a selling feature.
Wireless Application Protocol (WAP) is a standard for application layer network communications in a
wireless communication environment such as TETRA network. The protocol is used to access the
mobile web from a radio through a WAP browser.
5.22.1

WAP Browser

The Openwave Mobile Browser is a Wireless Application Protocol (WAP)-compliant user agent. The
WAP browser, available only in TMO mode and on a network with Packet Data enabled, provides all
the basic services of a computer web browser. Depending on the CPS configuration, the display can
return to the browser session automatically after an interruption by the preemptive display. The WAP
browser does not support right-to-left languages (as Arabic and Hebrew); English is used instead. The
characters of right-to-left scripts are not displayed.
NOTICE: Depending on the radio configuration and the network conditions, the WAP browser
may not display images properly (or may display them with a delay).
5.22.2

Entering the Browser

Prerequisites: From the home screen, press the Menu key. Set Setup → Data Setup to Data Only or
Voice & Data.
Procedure:
1 From the home screen, press the Menu key.
2 Select Browser.
3 Optional: Exit the browser by pressing and holding the E
Chapter 5: Features
key.
ND
68015000585-MF
137