Emergency In Dmo - Motorola TETRA MTM800 Manual

If configured by your service provider, your MTM800 will
automatically attempt to get talk permit again and the
message will be displayed.
For Mic
During this pending time the MTM800 microphone is not active
until the Emgcy Mic On message is displayed again.
Receiving an Emergency Group Call
A terminal in TMO receives an Emergency Group Call to the
selected group or associated ATG (Announcement
Talkgroup), or scanned group. If the ATG is the currently
selected group, the terminal will receive the Emergency
Group Call to the group associated with this ATG. (For
information on the ATG, see page 28.)
When the MTM800 receives the call, the display will show the
caller's identity. If the display is idle, it will show
.
Use
If upon entering Emergency mode your MTM800 receives an
emergency call, and Hot Microphone was enabled by your
Service Provider, the
Your MTM800 will attempt to get a talk permit.

Emergency in DMO

You can initiate an Emergency Group Call to a group.
You can receive a call from the selected talkgroup, and (if
configured by your Service Provider) from other users within
talkback range or from an open group. (An open group is a
super-group to which all DMO groups belong.)
Emergency calls can be placed via gateway and repeater.
For gateway and repeater settings, see "Gateway/Repeater
Selection" on page 40.
message will be displayed.
Wait For Mic
Wait
Emrgncy-In
61