Ctp2000 Platform Ssh Setup - Juniper CTP2000 Series Hardware Documentation

CTP2000 Hardware Documentation
Related
Documentation

CTP2000 Platform SSH Setup

Related
Documentation
114
When you power on the device, the CLI appears on your console's screen. You can
begin configuration.
Setting Up Management Access on the CTP2000 Platform on page 111
CTP2000 Console Port Setup on page 112
Using HyperTerminal with the CTP2000 Platform on page 113
CTP2000 Platform SSH Setup on page 114
When you have configured an IP address for the CTP2000 device, you can run SSH from
a host to access the device through its Ethernet port. To connect the Ethernet port to
the network:
Connect an RJ-45 cable to one of the two Ethernet ports of the CTP2000 chassis.
1.
This applies to the AC and DC power versions of the platform.
Connect the other end of the cable to the appropriate Ethernet network for an
2.
out-of-band connection.
CAUTION: Do not change the IP address for the Ethernet interface that you
are using to communicate with the device. If you change the address, you
will lose the SSH session.
Setting Up Management Access on the CTP2000 Platform on page 111
CTP2000 Console Port Setup on page 112
Using HyperTerminal with the CTP2000 Platform on page 113
Connecting Directly to the CTP2000 Platform on page 113
Copyright © 2017, Juniper Networks, Inc.