Ctp2000 Series Console Cable Pinouts - Juniper CTP2000 Series Hardware Documentation

CTP2000 Hardware Documentation
Table 19: CTP2000 Serial DTE Cable Pinouts (continued)
Cable
Related
Documentation

CTP2000 Series Console Cable Pinouts

58
J1 SCSI
45
96
46
97
47
98
48
99
49
100
50
CTP2000 Serial Interface Modules on page 11
CTP2000 FXS and FXO Interface Module Cables and Pinouts on page 45
CTP2000 Series Console Cable Pinouts on page 58
The console port CTP2008, CTP2024, and CTP2056 devices with the new PP833
processor uses a USB-type connector located on the right of the PP833 faceplate labelled
"RS-232". CTP2000 series devices with the PP310 and PP332 processors use an RJ-45
connected to the port. This cable must be connected during the first boot process.
COM2
Use a shielded cable for the
displays the console cable pin configurations for CTP2000 series devices with the PP310
and PP332 processors. On the left is the RJ-45 connector, and on the right is the DB-9
connector with the pin numbering indicated.
The console connections are configured to the following parameters:
Speed: 9600 bps
Data bits: 8
Stop bits: 1
DB-25
P3-21
P3-8
P3-10
P3-11
P3-24
P3-18
P3-9
P3-17
P3-25
P3-7
P3-1
COM2 port on the CTP2056 device. Figure 29 on page 59
Copyright © 2017, Juniper Networks, Inc.