Ctp2024 Platform; Figure 3: Ctp2008 Platform Containing The Pp332 Processor; Figure 4: Ctp2008 Platform Containing The Pp332 Processor - Juniper CTP2000 Series Hardware Documentation

Related
Documentation

CTP2024 Platform

Copyright © 2017, Juniper Networks, Inc.
Power supply—Use a standard IEC power cord for the AC version. Use a 22-AWG fork
terminal connector for the DC version. There is no power redundancy for the AC version
and the DC version.
There are no power switches on CTP2000 Series DC models, so a readily accessible
disconnect device must be provided as part of the electrical installation of the unit.
We recommend the 22-AWG wire for DC power terminals.
Ethernet connection—Provides the 1-Gbps Ethernet connection to the IP network by
means of a local Ethernet switch or router.
Console connection—Provides an asynchronous tty connection for locally configuring
the CTP Series device. On the PP310 and PP332 processors, you can connect a console
directly to the COM2 port (which is an RJ-45 type connector) found on the RTM panel.
Figure 3: CTP2008 Platform Containing the PP332 Processor (AC Version,
Rear View)
PMC I/O 2
Power input and switch
Not used
Figure 4: CTP2008 Platform Containing the PP332 Processor (DC Version,
Rear View)
RTN
-48VDC
ESD
Fuse
Power A input connector
CTP2024 Platform on page 5
CTP2056 Platform on page 7
The Juniper Networks CTP2024 Circuit to Packet platform can have up to three removable
interface modules and one removable processor module, and is available in both
AC-powered and DC-powered versions. It has a removable fan tray, and airflow is
side-to-side. Figure 5 on page
CTP2024 chassis containing the PP332 processor (which requires an RTM card for
Ethernet and console port accesses). The new PP833 processor module does not require
an RTM card. All PP833 module access is located on the front panel with all CTP serial
and T1/E1 ports. If you are upgrading from the old PP310 or PP332 processor to the PP833
Chapter 1: CTP2000 Series Platform Overview
COM2 COM3
Not used ETH0
Console ETH1 USB
PMC I/O 2
COM2 COM3
Not used
Not used Console ETH1
6, Figure 6 on page 7, and
PMC I/O 1
Not used
PMC I/O 1
ETH0 USB Not used
Figure 7 on page 7 show the
5