Juniper CTP2000 Series Hardware Documentation page 116

CTP2000 Hardware Documentation
Related
Documentation
100
Insert the module into the midplane by simultaneously pressing both ejectors inward
7.
and exerting forward pressure on the module. The small red release buttons should
click into place.
Tighten the module's captive screws using a Phillips screwdriver.
8.
NOTE: Tighten the captive screws completely before installing an adjacent
module so that proper electromagnetic interference (EMI) gasket
compression occurs. Failure to do this can make it difficult to install
adjacent modules.
Go to Cabling a CTP Interface Module.
9.
Removing a CTP Interface Module, Processor Module, or Clock Module on page 89
Copyright © 2017, Juniper Networks, Inc.