Using HyperTerminal with the CTP2000 Platform
Related
Documentation
Connecting Directly to the CTP2000 Platform
Copyright © 2017, Juniper Networks, Inc.
If your console uses a version of Microsoft Windows (such as Windows XP or Windows
NT 4.0) that supports the HyperTerminal application, you can access the device through
HyperTerminal.
Click the
button and select
Start
1.
HyperTerminal
.
In the HyperTerminal window, select
2.
In the Connection Description dialog box, enter a name for your device in the Name
3.
field.
Select any icon to represent your terminal emulation, and click
4.
In the Connect To dialog box, in the Connect using field, select the appropriate COM
5.
port to use (for example,
In the COM1 Properties dialog box, select the following settings:
6.
Bits per second: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: Xon/Xoff
Click
.
OK
7.
Setting Up Management Access on the CTP2000 Platform on page 111
CTP2000 Console Port Setup on page 112
Connecting Directly to the CTP2000 Platform on page 113
CTP2000 Platform SSH Setup on page 114
When you connect a console directly to the device, use the COM 2 port on the RJ-45
connector. To do this, you must use the special DB-9 adapter with a straight-through
RJ-45 cable. Direct access through the COM 2 serial port enables you to monitor the
device while it boots.
To connect a console directly to the device:
Connect the female DB-9 connector to the COM 2 port on the device's RTM.
1.
Connect the crossover adapter connector to your PC's serial port.
2.
Power on the device.
3.
Chapter 17: Accessing the CTP2000 Platform
Programs, Accessories, Communications, and
HyperTerminal
COM1
), and click
OK
.
.
.
OK
113