Ctp2000 Fxs And Fxo Interface Module Cables And Pinouts; Required Cables; Rtm Pinout Locations - Juniper CTP2000 Series Hardware Documentation

Related
Documentation

CTP2000 FXS and FXO Interface Module Cables and Pinouts

Required Cables

RTM Pinout Locations

Copyright © 2017, Juniper Networks, Inc.
Table 14: CTP2000 4WE&M RTM Pinouts–Connector B (continued)
Connector B
PIN Signal
8 Port 5 SB
9 Port 6 R
10 Port 6 R1
11 Port 6 SG
12 Port 6 SB
13 Port 7 R
14 Port 7 R1
15 Port 7 SG
16 Port 7 SB
25 GND
CTP2000 4WE&M Interface Module on page 14
CTP2000 FXS and FXO Interface Module Cables and Pinouts on page 45
CTP2000 Series Console Cable Pinouts on page 58
Required Cables on page 45
RTM Pinout Locations on page 45
FXS Connector Pinouts on page 46
FXO Connector Pinouts on page 47
The CTP2000 2W-FXS and 2W-FX0 interface modules require the use of double-shielded
cables (copper braid plus aluminum mylar foil) to ensure EMI Compliance.
Figure 27 on page 46 shows the pinout locations for both the CTP2000 2W-FXS and
2W-FXO interface modules.
Chapter 6: Cable and Pinout Specifications
Signal PIN
Port 5 M 33
Port 6 T 34
Port 6 T1 35
Port 6 E 36
Port 6M 37
Port 7 T 38
Port 7 T1 39
Port 7 E 40
Port 7 M 41
GND 50
45