Ctp2000 Console Port Setup - Juniper CTP2000 Series Hardware Documentation

CTP2000 Hardware Documentation
Related
Documentation

CTP2000 Console Port Setup

Related
Documentation
112
See "CTP2000 Series Console Cable Pinouts" on page 58
pinouts of PP310/PP332 and PP833 processor console cables, USB-to-DB9 cable,
and DB9-to-RJ45 adapters.
Remote console—Connect 10/100Base-T to an Ethernet port, and run SSH from a
remote console.
For initial access to the system, you need to physically connect your console directly to
the device's RS-232 port. Through this connection you use the CLI to set an IP address
on the device. After you configure the IP address, you can access the device remotely
(for example, through SSH).
CTP2000 Console Port Setup on page 112
Using HyperTerminal with the CTP2000 Platform on page 113
Connecting Directly to the CTP2000 Platform on page 113
CTP2000 Platform SSH Setup on page 114
You can connect a console terminal (PC, Macintosh, or UNIX workstation) directly to the
CONSOLE terminal port. When you connect a console directly to the device, you can
configure the device without an IP address. To communicate with the device, you must
have a terminal emulation program running on your PC or Macintosh. You can use any
terminal emulation program, such as HyperTerminal. A UNIX workstation can use the
emulator TIP.
You can connect a console to the COM2 port on the PP310 and PP332 processors. On
the PP833 processor, a console is connected using the supplied USB-to-DB9 cable (p/n
720-071594), in which the DB-9 connector has the same pinout as a standard RS-232
DTE port. When the USB-to-DB9 cable is used in conjunction with the DB-9 adapter
labelled "p/n 450-071855", the available RJ-45 console pinout will be the same as the
console connection on the RTM of PP332/PP310 processor.
Alternatively, if the DB-9 adapter from the bag labelled "p/n 720-056657" is used instead
of "p/n 450-071855", the available RJ-45 console pinout will be similar to the CTP150
console port (and other Juniper routers). To connect the PP833 processor with the DB-9
male serial port of a PC, additionally connect a straight RJ-45 cable with the DB-9 adapter
from the bag labelled "p/n 720-056657". The other end of the RJ-45 cable connects to
the DB-9 adapter from the bag labelled "p/n 720-014126". Then, you can connect the
PC's DB-9 male connector with the DB-9 adapter "p/n 720-014126".
See "CTP2000 Series Console Cable Pinouts" on page 58
pinouts of PP310/PP332 and PP833 processor console cables, USB-to-DB9 cable, and
DB9-to-RJ45 adapters.
Setting Up Management Access on the CTP2000 Platform on page 111
for information about the
for information about the
Copyright © 2017, Juniper Networks, Inc.