Configuration Mode Commands; Change The Out Of Band Management Ip Address; Enabling Igmp Snooping - ZyXEL Communications GS-4012 User Manual

C
H A P T E R

Configuration Mode Commands

This chapter describes how to enable and configure your Switch's features using commands.
For more background information, see the feature specific chapters which proceed the
commands chapters.

47.1 Change the Out of Band Management IP Address

Use the
ip address
on the Switch.
Syntax:
ip address <IP Adress> <Subnet Mask>
An example is shown next.
• Change the out of band Management IP address to 192.168.0.2
• View updated settings.
sysname(config)# ip address 192.168.0.2 255.255.255.0
sysname(config)# exit
sysname# show ip
Management IP Address
IP[192.168.0.2], Netmask[255.255.255.0], VID[0]
IP Interface
IP[192.168.2.1], Netmask[255.255.255.0], VID[2]
See example in
management IP address for the Switch.

47.2 Enabling IGMP Snooping

To enable IGMP snooping on the Switch. Enter
can also set how to treat traffic from an unknown multicast group by typing the
multicast-frame
GS-4012F/4024 User's Guide
command to change the IP address of the out of band management port
Section 48.2 on page 395 for information on how to change the in band
parameter.
and press [ENTER]. You
igmp-snooping
47
unknown-
383