ZyXEL Communications GS-4012 User Manual page 60

Chapter 4 The Web Configurator
Table 5 Navigation Panel Links (continued)
LINK
Auth and Acct
IP Source Guard This link takes you to screens where you can configure filtering of unauthorized
Loop Guard
IP Application
Static Routing
RIP
OSPF
IGMP
DVMRP
IP Multicast
DiffServ
DHCP
VRRP
Management
Maintenance
Access Control
Diagnostic
Syslog
Cluster
Management
MAC Table
IP Table
ARP Table
Routing Table
Configure Clone
60
DESCRIPTION
This link takes you to a screen where you can configure authentication and
accounting services via external servers. The external servers can be either
RADIUS (Remote Authentication Dial-In User Service) or TACACS+ (Terminal
Access Controller Access-Control System Plus).
DHCP and ARP packets in your network.
This link takes you to a screen where you can configure protection against network
loops that occur on the edge of your network.
This link takes you to a screen where you can configure static routes. A static route
defines how the Switch should forward traffic by configuring the TCP/IP parameters
manually.
This link takes you to a screen where you can configure the RIP (Routing
Information Protocol) direction and versions.
This link takes you to screens where you can view the OSPF status and configure
OSPF settings.
This link takes you to a screen where you can configure the IGMP settings.
This link takes you to a screen where you can configure the DVMRP (Distance
Vector Multicast Routing Protocol) settings.
This link takes you to a screen where you can configure the Switch to remove
VLAN tags from IP multicast packets on an out-going port.
This link takes you to screens where you can enable DiffServ, configure 2-Rate 3
Color Marker and set DSCP-to-IEEE802.1p mappings.
This link takes you to screens where you can configure the DHCP settings.
This link takes you to screens where you can configure redundant virtual router for
your network.
This link takes you to screens where you can perform firmware and configuration
file maintenance as well as reboot the system.
This link takes you to screens where you can change the system login password
and configure SNMP and remote management.
This link takes you to a screen where you can view system logs and test port(s).
This link takes you to screens where you can setup system logs and a system log
server.
This link takes you to screens where you can configure clustering management and
view its status.
This link takes you to a screen where you can view the MAC addresses (and types)
of devices attached to what ports and VLAN IDs.
This link takes you to a screen where you can view the IP addresses (and types) of
devices attached to what ports and VLAN IDs.
This link takes you to a screen where you can view the MAC addresses – IP
address resolution table.
This link takes you to a screen where you can view the routing table.
This link takes you to a screen where you can copy attributes of one port to other
ports.
GS-4012F/4024 User's Guide