Enabling Port Authentication; Radius Server Settings - ZyXEL Communications GS-4012 User Manual

Chapter 47 Configuration Mode Commands
• Enable dynamic link aggregation (LACP) on trunk 1.
sysname(config)# trunk t1
sysname(config)# trunk t1 interface 5-8
sysname(config)# trunk t1 lacp

47.9 Enabling Port Authentication

To enable a port authentication, you need to specify your RADIUS server details and select the
ports which require external authentication. You can set up multiple RADIUS servers and
specify how the Switch will process authentication requests.

47.9.1 RADIUS Server Settings

Configuring multiple RADIUS servers is only available via the command interpreter mode.
Use the
radius-server
Syntax:
radius-server host <index> <ip>
radius-server host <index> <ip> [acct-port <socket-number>] [key
--> <key-string>]
radius-server timeout <1-1000>
radius-server mode <priority|round-robin>
where
radius-server host <index>
<ip>
[acct-port <socket-number>]
[key <key-string>]
392
command to set up your RADIUS server settings.
= Specifies the IP address of the RADIUS server.
= Changes the UDP port of the RADIUS server
from the default (1812).
= Specifies a password (up to 32 alphanumeric
characters) as the key to be shared between the
RADIUS server and the Switch.
GS-4012F/4024 User's Guide