Gvrp Timer; Enable Gvrp; Disable Gvrp; Port Vlan Commands - ZyXEL Communications GS-4012 User Manual

The following example sets the Join Timer to 300 milliseconds, the Leave Timer to 800
milliseconds and the Leave All Timer to 11000 milliseconds.
sysname (config)# garp join 300 leave 800 leaveall 11000

49.2.3 GVRP Timer

Syntax:
show vlan1q gvrp
This command shows the Switch's GVRP settings.
An example is shown next.
sysname# show vlan1q gvrp
GVRP Support
---------------------
gvrpEnable = YES
sysname #

49.2.4 Enable GVRP

Syntax:
vlan1q gvrp
This command turns on GVRP in order to propagate VLAN information beyond the Switch.

49.2.5 Disable GVRP

Syntax:
no vlan1q gvrp
This command turns off GVRP so that the Switch does not propagate VLAN information to
other switches.

49.3 Port VLAN Commands

You must configure the Switch port VLAN settings in config-interface mode.

49.3.1 Set Port VID

Syntax:
pvid <VID>
where
<VID>
This command sets the default VLAN ID on the port(s).
GS-4012F/4024 User's Guide
Chapter 49 IEEE 802.1Q Tagged VLAN Commands
= Specifies the VLAN number between 1 and 4094.
405