Enabling Trunking - ZyXEL Communications GS-4012 User Manual

where
name <name>
mac <mac-addr>
vlan <vlan-id>
drop <src/dst/both>
An example is shown next.
• Create a filtering rule called "filter1".
• Drop packets coming from and going to MAC address 00:12:00:12:00:12 on VLAN.
sysname(config)# mac-filter name filter 1
sysname(config)# mac-filter name filter 1 mac 00:12:00:12:00:12 vlan 1 drop
both

47.8 Enabling Trunking

To create and enable a trunk, enter
press [ENTER]
Syntax:
trunk <T1|T2|T3|T4|T5|T6>
trunk <T1|T2|T3|T4|T5|T6> interface <port-list>
trunk <T1|T2|T3|T4|T5|T6> lacp
where
<T1|T2|T3|T4|T5|T6>
<T1|T2|T3|T4|T5|T6>
interface <port-list>
<T1|T2|T3|T4|T5|T6> lacp
An example is shown next.
• Create trunk 1 on the Switch.
• Place ports 5-8 in trunk 1.
GS-4012F/4024 User's Guide
=
=
=
=
trunk
.
=
=
=
Chapter 47 Configuration Mode Commands
Names the filtering rule.
Specifies the MAC address you want to filter.
Specifies which VLAN this rule applies to.
Selects the behavior of the rule.
• src - drop packets coming from the specified MAC
address
• dst- drop packets going to the specified MAC
address
• both - drop packets coming from or going to the
specified MAC address
followed by the ports which you want to group and
Enables the trunk.
Places ports in the trunk.
Enables LACP in the trunk.
391